Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Cisco Community,
I'm new on configuring tacacs, hope you can help me.
I have a issue, every time I log in using my TACACS+ account it still ask me for the enable password
based on the config below, what is the command here that still asks me...
Hi Cisco Community,
I'm new on configuring tacacs, hope you can help me.
I have a issue, every time I log in using my TACACS+ account it still ask me for the enable password
based on the config below, what is the command here that still asks me...
Hi,
I would like to address this, if find it very weird.
Set up:
Management - VLAN1
User - VLAN 1
So the thing is if your management is intermittent and if its the same vlan with your users, it will also be intermittent right? Since you are in t...
Hi,
I'm having problem configuring the privilege mode of the 2960 catalyst, every time i configure the command:
IOS: "flash:c2960-lanbase-mz.122-25.SEE2/c2960-lanbase-mz.122-25.SEE2.bin"
username test privilege 5 secret test
privilege exec level ...
Hi Team,
I am just new on the BGP world, I am having trouble on Active Standby function of BGP protocol. Please see the details below.
Goal:
To establish active standby connection, If connection between R3 [50.50.50.0/30] and R1 [10.10.10.0/30] got ...
Yes sir, but that's the use of "local" right? if the tacacs server is not reachable from the network device, it will use the local credentials. If I use the "none" command, if the device cannot reach the tacacs server it will not look for the local c...
Hi Paul,
I just saw the configuration here and planning also to remove the "0" since it cant do anything.
aaa authorization exec default group tacacs+ none --> for this one, shouldn't I use local instead of none on all my configs? so If the tacac...
