Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Afternoon all,
I'm looking for a bit of advice regarding setting up our NMS to correctly handle IP SLA Timeout traps for the following from our Nexus 7K when SLA's timeout:
ip sla reaction-configuration 1 react timeout action-type trapOnly
I've b...
Hi all,
I am looking for some assistance with a proactive issue I have picked up on a couple of our larger call centre networks.
For these sites we have a resilient Core setup of 2 x 3560e running GLBP between the 2, for the 30 or so configured VLA...
Hi there,I too am interested in the answers to this When this tool reports that "Flash inaccessible", does it mean that the WLAN Poller tool cannot proceed in any way, and then one needs to reboot the AP to proceed (as it states??) I take it if set ...
Update:So these are what were compiled and added into our EMS: We have compiled the MIB file given and got the below trap definitions. Trap OIDClassNameInstanceNameEventNameSeverityEventTextExpirationState.1.3.6.1.4.1.9.9.42.1.2.1.1.3 6 4SNMPTrap$SYS...
Thanks for the response
I've not tried increasing the GLBP timers just due to the other VLANs/Access Switches not experiencing the same problem, yet having the same timers. Will give this a go though.
I did try tracing the topology changes though
C...
