Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have some users complaining about connectivity issues to our VPN gateway, which is running on a mix of Cisco ASA and Firepower running ASA image under vpn load-balancing. Basically, they connect and after some time, they get this reconnecting issu...
I have a device with the below specs. Currently its running "asa917-4-smp-k8.bin"I am planning on upgrading this to "asa992-9-smp-k8.bin". Hardware: ASA5525, 8192 MB RAM, CPU Lynnfield 2394 MHz, 1 CPU (4 cores)ASA: 4096 MB RAM, 1 CPU (1 core)Internal...
I have a cisco ASA cluster for remote VPN connections(Anyconnect) . As seen below, when you use show vpn-sessiondb, you can see there is only 1 IPSec tunnel, used to monitor the VPN load-balancing cluster status. Our reporting tool (Cacti) , sometim...
Lets say I have the below config. interface GigabitEthernet0/0/1description testencapsulation dot1Q 201ip address x.x.x.xno ip redirectsno ip proxy-arpstandby version 2standby 201 ip y.y.y.y.y standby 201 timers msec 500 2standby 201 priority 200st...
I don't want to mess around with DTLS or MTU at the moment, as it has been working fine for some years now. I asked the customer to run DART, but I don't see anything useful in the log during the "Reconnecting" phase or before. I'm looking at this fi...
