Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Team,I am in a process of replacing the Cisco ASA 5510 with 7.3 OS with a new Cisco ASA 5515X with 8.6OS. In the existing Cisco ASA 5510, we have configured 'no nat-control' for which the traffic from all sub-interfaces were flowing to the lowe...
Hello Experts,I was searching for a IOS for our C4506 switch SUP II+ engine, with following features. I had searched in the software advisory on cisco.com but no help.1. PBR with multiple tracking options2. IP SLA3. No EIGRP stub routing.Appreciate y...
Hello Experts,I have a C4506 switch with SUP II+ module and 12.2(25)EW IOS loaded. I need to configure IP SLA responder to track a remote router and have tracking integrated with a PBR. I have configured the tracking and rtr responder, but unable to ...
Hello Everybody,I was looking for a IOS which can support IP SLA on our C4506 switch. Currently we have 12.2(25)EW installed and need one IOS of the same 'Basic L3' category which could support IP SLA.ThanksArabinda
Hello Experts,Recently we subscribed for 6mbps line from a ISP and they have provided 4 T1 lines. The hardware we are using is a Cisco 2811 router with 2nos VWIC2-2MFT-T1/E1 - 2-Port RJ-48 Multiflex Trunk - T1/E1. I terminated the lines from ISP and ...
Thank you Juoni.Do you think the following configuration should work?interface Ethernet0/0 speed 100 duplex full nameif outside security-level 0 ip address 10.x.x.x 255.255.255.224interface Ethernet0/2 speed 100 duplex full no nameif no security-leve...
Hello Zeeshan,Sorry I meant the software should not feature EIGRP stub routing, since we have few stub branch office connected. So searching for a software with IP SLA, PBR with multiple tracking options, but no EIGRP stub routing.Unfortunately in th...
Thank you Zeeshan. The real problem is the SG series IOS, or the enterprise class IOS has a problem that, they do not support EIGRP stub networks. Recenlty we upgraded, but one of our eigrp stub network lost connectivity.
show controller, show the below output. Please suggest.T1 0/0/0 is down. Applique type is Channelized T1 Cablelength is long 0db Transmitter is sending remote alarm. Receiver has loss of signal. alarm-trigger is not set Soaking time: 3, Clearan...
