Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a cisco 2921. I have 2 networks that has its own router192.168.1.0 network is connected to watchguard firewall192.168.9.0 network is connected to the cisco 2921 router.I want to connect the 2 subnet using one of the interface of the cisco rout...
I am configuring a vpn ipsec tunnel with cisco isr 2921 router and Watchguard edge 1250e. I have the watchguard configured so I just need to make sure I have everything setup on the cisco side. At this point, there is no communication as I am not sur...
All, we have a cisco ISR 2921 router. We want to connect century link dsl via PPPoe on Gigabit int 0/0. G 0/1 is configured for a switch LAN. I think I may have missed a configuration on the router as It is not passing traffic. Do I have to configure...
Liam, I cant ping any host on either subnet. The only thing I can ping is both 1.1.1.1 and 1.1.1.2 on both 9.x and 1.x network. So from the watchguard network 192.168.1.x i can ping 1.1.1.1 which is on the cisco interface. Also, from the cisco netwo...
Im currenlty setting up the watchguard for RIP. I am able to ping 1.1.1.2 from the 192.168.9.x subnet but I cant ping anything in the 192.168.1.x network. when I do a "show Ip protocol" under routing for networks I see 192.168.9.01.0.0.0under routin...
