Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am trying to upgrade an ASA5506-X SFR module (currently running 5.4.1.2-23) to the latest s/w version (5.4.1.3-26).However, the upgrade fails (after 5 hours!) with the following message:"Update Installation Failed : [59%] Fatal error: Error runn...
I have an ASA ruuning OS 7.04, configured to allow traffic to pass through without NAT. I've used ASDM to set up some site-to-site VPN tunnels, and it has added NAT 0 rules to the configuration.When I try and PING through the VPN tunnel, the ASA gene...
Hi,Is it possible configure GRE tunnels on a Catalyst 4500 Supervisor Engine V running the Enhanced Lyer-3 IOS?The IOS feature navigator would suggest GER support is included in the IOS, but I can find no references to GRE or tunnel interfaces in the...
I need to limit access from the DMZ to a resticted list of IPs/Ports on the inside n/w, but the DMZ machines must also be able to connect to the Internet (i.e. unknown IPs). (I have disabled NAT between DMZ and Inside)If I apply an access list to the...
(Apologies if this question has appeared twice)Can a remote-site VPN3002 tunnel more than one network back to a central VPN3000 concentrator? i.e. remote site networks in addition to that defined by the VPN3002 private interface IP address/subnet mas...
We have been advised to Generate admin persona certificates for all ISE nodes in the deployment with their IP as a SAN field:https://bst.cloudapps.cisco.com/bugsearch/bug/CSCva56322/?reffering_site=dumpcr
I have a 9-node ISE deployment (2 x Admin, 2 x M&T, 5 x PSN) with exactly the same issue.The deployment was upgraded 1.2->1.4->-2.1. Working fine until the 1.4 PAN was moved over at the end of the upgrade process. Promoting the Secondary Admin Node t...
I'm using ASDM 7.4(1) so will try again with 7.5(1).Failing that, I will link the 5506 to FireSIGHT Management Center and try it that way...-ChrisEdit: ASDM update failed again with the following message:Update Installation Failed : [59%] Fatal error...