Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a Cisco ASA 5505 firewall running in transparent mode. The configuration is fairly basic- a management IP, basic threat detection settings, inside/outside VLANs etc. This firewall normally has one server connected to it- this works fine. H...
I have a cisco ASA5505 configured in transparent mode. This evening we attempted to plug a couple of new servers in but they simply didnt work, despite our test server working absolutely fine. The server IP's are all in a network object group (the sa...
Thanks for your replies Ryan.I don't have a network diagram right now but can get one made. The firewall would need to stay in transparent mode as the servers its protecting cannot use NAT (they have public IP's they have to be used with).The three s...
It's worth noting that the servers we're trying to plug into the ASA (apart from our test server) have a different default gateway set in their network interfaces file than the xx.xxx.132.1 address. Would I need to set these servers to use the 132.1 ...
Hi,Thanks for the reply. The ASA is a new deployment- I've just plugged it into a switch in the DC. The default gateway is the same IP i specified in the static route- xx.xxx.132.1. Without this static route the management IP will not work, although ...
