Hi,
I have been tasked to migrated 3 firewalls into 1 FTD HA pair. After completing several 1 to 1 migrations this is my first many to one.
Can the migration tool be used effectively to do this task, what is the best process?
Thanks
Hi, I am in a situation where I need to check the MD5 on the two WLC .AES images below. AIR-CT2500-K9-8-5-105-0.aesAIR-CT2500-AP_BUNDLE-K9-8-5-10 5-0.aes The "show flash:" or "show dir" command does not work on the WLC CLI like a router or switch so...
Hi, I am having brain fog and wanted to know what is the best way to setup routing between two sites that are connected via a 3rd party managed LAN extension.The 3rd party is configuring all the site to site connectivity through their NTE and will pl...
What are the basic requirements and commands needed to build a layer 2 transit network between two sites?Both sites will be connected by a 3rd party router which I do not have access to.I will have access to the 3850's on each site.
Actually after reviewing the config the core 1 switch connects directly to the FirePOWER and the 3rd Party router such as the image attached.the int it connects on is gi1/016 and its config is shown. Just a generic access port on vlan 902 nothing els...
Hi, I've drawn out the diagram. As mentioned the ISP with be doing the link from network one to two I will need to do the routing. I am thinking I will need to create a new vlan interface on each side such as vlan 500 give it an new ip/subnet of 192....
So you have computer that have both wired and wireless UP & UP? Yes I believe so. Are the wired and wireless IP address under the same subnet?No Wired use 10.12.242.0/25 and 10.12.241.0/25 If wired and wireless IP address are different subnet, RTP do...
So you have computer that have both wired and wireless UP & UP? Yes I believe so. Are the wired and wireless IP address under the same subnet?No Wired use 10.12.242.0/25 and 10.12.241.0/25 If wired and wireless IP address are different subnet, RTP do...
