Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I am not sure if I am posting this is in the right place, however I have limited options to post my questions.I have done CCNA (R&S), and I no longer work on networking only, I am working on a role that is more storage dominant and requires me...
I have the below setup and I want to get a Cisco router to enable failover between my ISP links.At the branch end, failover happens as there are only connected to the Headoffice MPLS lines.Whereas in the Headoffice, failover does not happen, and we h...
When I define a static route as "IP route192.168.20.0 255.255.255.0 172.17.1.2 10" and unplug the cable, I am unable to ping the device 192.168.20.254.Traceroute command has no entries for all 30 hops.Also, when I define routes with AD, they don't r...
Sorry Tom, should have been clearer.Goal is to achieve failover when the primary link goes down.I have done the following:Assigned 2 static routes to each site via ISP A and B.ISP A being the primary link.Configured IP SLA 1 to monitor the connectivi...
Thanks Alain and Tom.I have configured the below scenario.When I remove the route with the red X, the track reachability goes down (which is correct).When I ping the device 192.168.20.254, I get a reply.How so I verify that the router is learning tha...
Hi,I am trying to configure IP SLA responder on a Cisco 1841, IOS 12.4T.corp(config)#ip sla responder tccorp(config)#ip sla responder tcp-connect ? ipaddress Permanent address port Permanent portWhen I give the IP address as 172.16.1.2 255.2...
