Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have many point to point GRE over IPsec tunnels for my OSPF routing.I've been working on correcting MSS and MTU values to prevent issues. But something puzzles me :agde06rtr03#show int tunnel 1Tunnel1 is up, line protocol is up Hardware is ...
Hi all,Back with another question / issue on my OSPF routing I have 2 ASBR routers, AGFR01RTR03 and AGFR02RTR03, performing OSPF to OSPF redistribution in both ways for the same ASs. They also do summarization for our private addressing scheme. It is...
Hi all,I have two 7604 routers running IOS 12.2(33)SRB5a as ASBRs in my network. They both connect to a common AS via DS3 lines.FR01 is considered my main circuit, FR02 is the backup. But I have some heavy disk sync traffic I want to route via the ba...
Hi all,I needed to upload new code to my catalyst 4948-10GE using X-modem and changed confreg from ROMMON as I usually do.Now the speed is set to 56700 bauds, I can see the initial boot on my screen using putty or hyperterm but I can't type anything....
Hi everyone,I have an office with a 4507R chassis running with sup engine V-10GE. The two 10Gbps interfaces are currently unused and I have a X2-10GB-SR module ready to be loaded in there. On the other end, I have 3x3560G delivering connectivity on t...
I do not understand your question : What exactly is your goal ? Being informed that an IP SLA operation failed ? That your routing table has changed ? I'm unsure on what exactly you're trying to achieve.Tom
Hi Peter,I found out that the OSPF external route administrative distance was 115 on process 53 also. Therefore, no tie breaker was existing and would still be "first installed wins". I took out the setting on ospf 53 and agfr01rtr03#show ip route 1...
Hi,IP SLA responder is only needed on IP SLA destination devices where certains statistics are required (MOS, UDP jitter).In your case, simple reachability operations are good enough and won't need no responders.Just create your operation :ip sla 1i...
Hi Rick,Here is the complete output :interface Tunnel1 description *** blablabla *** dampening bandwidth 50000 ip address 10.5.4.46 255.255.255.252 no ip redirects no ip unreachables no ip proxy-arp ip mtu 1400 ip pim dense-mode ip tcp adjust-mss 13...
