Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello guys !I have the following query but I am not sure if I am posting the thread in the right category.is it possible to use the SCE to redirect traffic towards bluecoat caching systems?if yes what is the granularity level for that? is it on layer...
Hi GuysWe have two CSS one Master and the other is in backup mode.We are getting the below message regarding the same duplicated IP address on both CSS but each one with different mac address. However, the OUI "00-1f-9e" shows that this for a Cisco ...
Dear Support, We are getting a huge amount of messages on our Monitoring system from our 3750 switch. Can you please advise what's wrong?Tue Dec 07 09:20:00 Got 271 byte SNMP Trap from: 10.160.124.166Tue Dec 07 09:20:01 Got 273 byte SNMP Trap fro...
Hi All, can anyone explain what does mean the below logs messages? Is something critical and how can we fix it? Host 0021.5a79.65a6 in vlan 100 is flapping between port Gi2/0/20 and port Gi1/0/20Host 0021.5a79.64ca in vlan 100 is flapping between p...
Hi All, I have done the syslog remote configuration on the switch. However, logs are not being received to the server and when doing capture on the firewall, we have noticed that the switch is not sending the logs to the default port UDP 514 but to r...
OK will do. I assume once done this will disable the switch from sending these notifications.Thanks again from you support. I will let you know if I face any issues.
Thanks Brahadesh for your prompt response.How can i disable sending these notifications ? Is it something that could be done from the switch? what are the commands?Thank you again for your help.
Below the OID. Hope this clarify the content of the trap. Any idea what could be the problem?Wed Dec 08 08:45:28 event type:.1.3.6.1.4.1.9.9.41.2.0.1,oid length:12,specificType:1 clogMessageGenerated1.3.6.1.4.1.9.9.41.2.0.1 Appreciate your help gu...
Basically let me explain more the setup. We are having two Cisco switches connected to each other via a Stackwise cable. The ports having this issue are access ports and they are connected to the same server using two different NIC cards.
