Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Ok, I have been out of it for a while, now it is kicking me.Problem. Have to install a router in a network, with some restictionsall things like SNMP, TACACS, Radius, NTP etc must be set up to use loopback0 as the source.this is on a 2811 router. ...
I have 4506 that is used in a lab environment. We utilize the 192.168.X.X split up into vlans vlan 2 assgined ip address 192.168.0.1vlan 3 assigned ip address 192.168.1.1vlan 4 assigned ip address 192.168.2.1 vlan 5 assinged ip address 192.168.3.1...
I have a problem that I need some help with. I have a copy of cisco works loaded on two systems. I'm trying to manage a bunch of Cat2950s. Problem is that on one when you bring up one of the 2950s in the cisco view it will allow you to monitor an...
I'm running the Cisco Small Network Management System and have a problem. Is there any way to limit which users have access/change ability on which switches in the SNMS. So far everything I have tried they all can either edit everything or nothing....
Here is my problem. outgoing traffic is nated behind a 3620Fa0/0 is a 131.242.18.xFa0/1 is 192.168.0.125this hooks into an old 4003 all vlan 1all systems hooked on it are in the 192.168.0.X range.I have a 4506 that is hooked to the 4003. Port fa2/1 ...
sorry for the delay in resopnding.I tried to apply the acl to the vlan. One in and one out. That did not work.I was not using the reflexive ACL's.I will work on getting a copy of my config off the test network so that I can send it out. bassicly I...
Made the change on the 4506, removed the assingment of the IP to the port and moved the port to vlan1.Problem is when I did that the rest of the routing on the switch ceased to work.The port on the 4003 to the 4006 is set up as a basic access port. ...
the old 4003 is not doing any routing. In fact it does not even have any vlans set other than default for the old Sup 1 card. The 4003 is bacily working as an expensive old hub. here is the 4006 configversion 12.2no service padservice timestamps d...
