Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi:I was having a port-security problem today on a 3750 switch.The troublesome port, Gi0/36, had only one computer connected. Whenever I enabled port security on the port, it immediately went into an err-disable state.i even tried allowing 100 mac ad...
Hi:I'm a bit puzzled by something:I plugged my laptop into a 3750 switchport and it got an address via DHCP.My question is, why?The switchport is g3/0/29.The configuration of that port is blank. It just reads:interface GigabitEthernet3/0/29.A "show v...
Hi:I've recently taken over the management of a group of switches, and have a question about a configuration.One interface has the following setup:interface GigabitEthernet1/0/40 description Trunk to HPCore switchport access vlan 10 switchport trunk ...
Hi:Can anyone tell me how to shut of wireless admin access on a 1131 AP?I only want to be able to administer the device via the wired LAN.I need to shut of http, ssh, and telnet.I haven't been able to find anything in the GUI.Anyone know the CLI comm...
Thanks for the link to that great discussion.But there appears to be a few different opinions:I read:"According to the command description and security recommendations/best practices the command "switchport mode access" will prevent processing of dot...
OK, thanks for the info. I figured it was only an access port, but with the HP switch on the other end was setup for both vlans, I just wanted to be sure.So what happens when this switchport receives a dot1q tagged frame? Does it ignore it?
dmantill:Thank you for your reply!Of course, access-lists to the rescue!The wireless network is 192.168.x.x, while the wired network is 10.x.x.x, so an ACL on the http server and vty lines should do the trick. I wil give it a try on Monday.Thanks for...
Hi Surendra:Thanks for your response.I'm still a bit unclear....Is there a way to allow http/telnet/ssh from the wired LAN, but not from the wireless LAN?I can do this on my cheap, home Linksys router, so is there a way to do this on this Cisco AP?I ...
