Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,We have a pair of 6296UPs at one of our sites and the website on the device freezes almost every time. When you try to log into the device, you get to the page to select UCS Manager or the KVM. Clicking UCSM often doesn't load and sits on the ...
We are attempting to boot 3 UCS C240 M4SX servers from iSCSI volumes on Windows 2022. We have the iSCSI connectivity configured on the vNIC and can see the volumes in BIOS. When we load into Windows Setup, we install the network drivers and the NICs ...
I have the networks team checking those items on the uplink ports. The login page works on both of them, which seems weird. I'm going to try a failover with a change ticket open next week.
Unfortunately, that didn't seem to fix it. This problem started after we did our upgrade last year and was ignored until now. /shrug I guess it is what it is.
Hi Kirk,Thanks for replying. We have it booting in legacy and we do have jumbo frames (they work with ESXi) but they are not configured on the networking on the servers right now.We have the vNIC driver installed in the Windows installation and it is...
That is so not helpful. It doesn't say anything other than this one version. Mathea - I would operate under the assumption that all versions of UCS are vulnerable unless they've been updated. You could open a case to ask if you have access to do that...
