Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am trying to create a dial up VPN on an ISR4331 (as you might see from another post I've tried PPTP with little success). I have tried L2TP/IPSEC and IPSEC trying to connect from the native VPN client in an android phone however the two ends seem i...
Hi
I've recently replaced an 1801 with an ISR4331. I previously had a PPTP VPN set up for occasional remote access to a server inside the network while not at the site from laptops or mobile phones. I have copied the config across to the new router...
Hi
I am trying to use a common VLAN between the built in layer 3 ports and a 4 x GE NIM.
The reason being is that I require the use of the fibre port due to distance and the copper ports as there are a few devices connecting directly. My config is ...
Hi
I'm deploying 2 ASA clusters onto the same LAN segment in multi-context mode. When creating the interface and assigning it to the context it seems as though the ASAs have used the same MAC on each pair. Where can I go to change this so that fai...
Hi
I'm fairly new to the ASA platform after having spent the last few years on Juniper SRX.
As part of a new project we are looking to integrate some ASA5545s into a new L3VPN platform and as part of this I'd like to have traffic fail-over between s...
Hi. I am running an ISR4331 on 15.5(3)S6.
I think I may have sorted that issue at least in that I had not correctly configured the group ID on the android device. I now get the tunnel up but get no traffic passing on it. How does the tunnel work i...
After some time away from this issue I managed to get the appx trial sorted out however I'm still not able to get traffic across a VPN.
If mppe encryption is enabled the router logs an error saying full virtual-interfaces are not supported. If I rem...
Hi
I dont think that doc is specific to my question. The problem is I am trying to use 2 different types of interface, the built in layer 3 and add-in layer 2 NIM. They do not support the same type of configuration so that may be where the issue i...
