Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
R1--x21--Modem1---------Modem2--v35--R2All, I have a network as illustrated above. The modems are Comtech satellite modems; modem2 is internally clocked (DCE), modem1 is looptimed clocked(also DCE, but gets clock from modem2). The routers are DTE's. ...
I have two 3750ME switches connecting two ends of a LES100. On each switch, i have 3845 routers with the NM-CEM-4SER modules, plus direct to switch internet traffic. My complete setup is as shown in the attached PDF. My problem is that with the defau...
Please does anyone have real life experience implementing the above module on any Cisco router ? I'm doing so presently, but the performance has not been consistent, to say the least.
Hi,I am trying to set up circuit emulation over IP using NM-CEM-4SER on two 3845 routers. The routers are at two locations connected by a Leased Ethernet 100 (LES100) circuit. The LES100 works fine; i can telnet to either router from the remote locat...
Hi,You can use DITG http://www.grid.unina.it/software/ITG/I'm using it to test QoS right now. It has a Java front. You mark traffic, send UDP,TCP,ICMP etc, and send multiple streams. Its pretty good. Install it on two PC's, use the GUI, and of you go...
I'm running C3845-SPSERVICESK9-M. Version 12.4(15)T1. My setup is as below; BERT tester------3845 router with CEM-----Satellite modem(remote location)------------------------------------(teleport)Satellite modem---3845 route with CEM with network lo...
