Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, What is the best possible configuration to implement QOS for live streaming in a layer 2 environment.Its completely cisco switch environment and streaming source and clients are connected in two different L2 switch with maximum of three hops. st...
Do we need to configure RP ? in case if there is only one L3 switch with SVIs and multicast need to be enabled in multiple vlans terminating on this switch with leaf switches just acting as L2. To learn the mrouter by L2 switches, IP PIM is enabled i...
Hi,
If called internally within the office via (Internal network) is working fine. In such a scenario, I tried to make a call internally using DID then it won't work out. Example:
1. Called party : 2015018 to calling party : 2014777 (No Issue). Wo...
Hi,
I am looking for some example to configure QOS with the below requirements.
Strict Priority queue scheduling for
QUEUE 4 -HIGHEST PRIORITY- DSCP 46 EFQUEUE 3 -next priority-DSCP 34 AF41QUEUE 2 -next priority-VoIP / VIDEOQUEUE 1 -LOWEST PRI...
Hi,
Will I be able to connect 10G Twinax cable from server to one of the 10G port of C9300-NM-8X module ?
Is there any way C9300-NM-8X supports 10G copper Termination ?
Thank you. In case if Multicast is not needed to be routed between different vlans, hope i don't need RP then. In my case multicast needs to be worked with in same vlan across multiple switch but between vlans.
Do we need to configure RP ? in case if there is only one L3 switch with SVI and multicast need to be enabled in multiple vlans terminating on this switch with leaf switches just acting as L2.
Thank you for your response!We are having PT-NYC-Lines partition - associated with the DN (2014777).Kindly let us know what would be the next step to analysis?Thanks,Vinoth.
