Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,i have a multiple ipv6 addr loopback interface (no matter, why :-)), and I would like setup a BGP session on the secondary address. Unfortunatly, the command "update-source" works only if the session is established on the first IP addr.Is there an...
Hi guys,i've got a ASR9901 acts as BNG, with dynamic-template for subscriber interfaces creation and PPPoE via radius auth, by the RemoteID that the network attach to PADI request. All works fine.Now a new, wholesaler supplier doesn't implement inter...
Hi Guys,I'm looking for the best way to monitor L2VPN xconnect via EVPN + MPLS tunnel on the NCS55XX (xr 7.1). I'm looking for SNMP index on CISCO-IETF-PW-MIB but cpwVcTable result empty. snmptable -v2c -c XXXXX -m CISCO-IETF-PW-MIB -IR -Ci 172.17.2...
Hi All,
i'm using on IOS-XR Version 5.3.4, BGP Next-Hop Tracking (aka BGP-NH-TK), with this RPL:
route-policy NEXTHOPTRAKING-FILTER if destination in PFX_NEXTHOPTRAKING-FILTER_V4 then pass else drop endifend-policy
with:
prefix-set PFX_NEXTHOPTRA...
Hi,
i'm running IOS XR 5.3, and customize some Netflow configuration, but during monitor-map config i have a found a cmd that i can't understand.
flow monitor-map NETFLOWMM4
option outphysint
description say: "outphysint export output interfa...
Hi John, thanks for you Answer i think that your're wrong because N1Kv support VXLAN with KVM in an openstack enviroment. (for example http://www.cisco.com/c/en/us/td/docs/switches/datacenter/nexus1000/kvm/config_guide/vxlan/521sk122/b-Cisco-N1KV-KVM...
