Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a customer that have ISE enviorment with to kind of catalyst switches Cisco 9300 and Cisco Model: C1000-version IOS: 15.2(7)E3.If they take a PC that is alowed to access their organisation and connect to the switchport on the Catalyst 9300 or ...
I am about to uprade two FTD 4110 FXOS. The first upgrade has been succeced on the Secondary and then I tried do run the same steps on the primery FTD. I has been runing upgrade in more than 2 hours on the primery FTD now and I am soure that some thi...
Hi everyone
I am trying to Upgrade a Cisco ISE PSN and getting this error:
********
STEP 3: Validating data before upgrade...
%warning: Cannot upgrade this node as new PAP has patch(es) installed on it, please remove the patch(es) and try again.*****...
Hello every one
I have a ChackPoint firewall configuration that I need to convert to Cisco. Is there any tool I can use for the converting.
I have tried to download one from Cisco.com
https://software.cisco.com/download/release.html?mdfid=28058280...
Hello
I have a IPsec lan-to-lan tunnel between a Cisco ASA and Cisco ASR1001.
I can see that the Phase 1 is OK:
SDN3-HUB-1#sh crypto isakmp saIPv4 Crypto ISAKMP SAdst src state conn-id status1XX.XX.XXX.XXX 9X.XXX.XXX.XX QM_IDLE 1118 ACTIVE
IPv6 Crypt...
Hi Marvin Thank you for response. As I mentioned abow here the chassie has been reboded. You are right 2 hours is excessive for an upgrade. It took almost 45 min for ograding the first FTD 4110 chassie. Actuly I did open a TAC case and I am trynig ...
