Hi, We are running firmware version 7.4.6 and in SIP mode with BoradWorks. The issue we are having is that when issuing a Rebuild File and Reboot from BroadWorks Device Management System, the 525 will reboot once and download the latest configura...
Has anyone successfully setup an SF 300-24P to Automatically Assign a Voice VLAN to traffic recieved from a Polycom IP Phone? We have LLDP-MED enabled with a the Policy assigned to the port, along with the interface configured as a Trunk with the PVI...
Hi Larnel, You can do this by setting the 3750 for 802.1Q ecapsulation on the trunk port, set the native vlan, and allow VLAN's accross. On the SF300 you would perform the same process create the trunk port, allow the VLAN's, and set the PVID to ...
Yeah, we ran accross the same problem on 7.4.3, what we ended up doing is manually upgrading to 7.4.6 which then allowed the phone to use the upgrade URL toupgrade via TFTP to 7.4.7. You may want to take the phones to the lates firware which is 7.4.8...
Try disconnecting the switch from the router, and rebooting the switch. This should set the IP Address back to default since there is not DHCP server available, if not you may need to console in to assign the Management IP Address. This should then a...
We ran into the same problem a while back. The only way we were able to get the switch back online was to break theboot sequence, restore the switch to factory default, and restore a backup of the configuration. Hope this helps you folks.
