Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am trying to setup my first ever easy VPN on my Cisco RV325. I believe the first step is to configure the static IP on the WAN port that is connected to my cable modem. The problem is the service provider is not providing a static IP but instea...
Ok - here are a few key factors that relate to my question:-Every switch is a Cisco Layer 3 Switch (3560G)-All IP VLANS are defined on the drawing attached to this discussing, -Every port on ESW605-1 switch has an IP of .3 (on the respective vlans th...
Hey Guys,Let me start off by saying I am a newbie to Cisco. I have some very basic knowledge on how the IOS works.That being said - I am looking to deploy Cisco Network Assistant to manage 5 Cisco 2960 switches.Each switch was pretty much unwrapped f...
if you click on the picture, it will enlarge greatly.Not right now, I havent configured any IP's yet on anything. End result I am looking to accomplish:Access to:192.168.0.0/24 (NTP Server Network)Access from:172.33.100.0/24172.34.100.0/24172.33.100....
I got it to work on my test switch. I cannot get it to work on my live switch - ping responses do not work on the switch or on laptop... can you see why?I gave it IP ip address 192.168.16.49 255.255.0.0My laptop is using 192.168.16.249 255.255.0.0I ...
Wow - thank you so much for this response! I really do appreciate it. Before I posted, I tried to configure VLAN1 with an IP. Below is what I did:switch>enableswitch#conf tsw1(config)#interface vlan 1sw1(config-int)#ip address 192.168.16.1 255.255.25...
