Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a port mirror in place - with a sniffer on the destination port. We cannot access the sni via IP "through" the destination port - is that by design?
I am unable to get ping replies from my FTD outside interface when pinging from the Internet. I can ping out, through the FTD to Internet address from internal clients. Basically, if I do an nmap scan from outside - I see no open ports on my FTD. ...
Hello all,
I have a simple question. I have 2 ASA 5510 in Active/Standby. Active INSIDE IP is 10.1.0.3, failover is 10.1.0.4. Due to an asymmetrical routing issue - I need to change the INSIDE IPs to 10.5.0.3 and 10.5.0.4 respectively. I have a...
Hi all,
I have 2 ASA-5510s running 8.2.5-58 running in Active/Standby.
I bought a single AnyConnect Essentials license, registered to one of my ASA firewall serial numbers, and installed it....but it disabled my failover with this message:
activatio...
I am running 2 ASA-5510 firewalls in Active/Standby.
I recently purchased a single AnyConnect Essentials license - but I had to "Activate" it to a serial number - so I used the current "Active" firewall.
My question is, will this license install o...
Me again.
So, I ran packet-tracer with the detailed flag to see what was happening.
Basically, all phases pass -the packet gets through the ACLs, Snort, etc.
The final result is:
Result:input-interface: outsideinput-status: upinput-line-sta...
Further craziness - this FTD is part of a HA pair. I CAN ping the 2ndary external IP - but not the primary. If I take the primary unit offline (to force a failover - I still cannot ping the primary external IP - even though the device that now ho...
