01-04-2016 01:12 PM - edited 03-12-2019 12:06 AM
I am running 2 ASA-5510 firewalls in Active/Standby.
I recently purchased a single AnyConnect Essentials license - but I had to "Activate" it to a serial number - so I used the current "Active" firewall.
My question is, will this license install on both systems, or do I install it on the correct s/n machine and it will "replicate" over to the spare, or do I need to buy an additional license for the other firewall.
These are not clustered, or running Active/Active.
Thanks,
Eric
Solved! Go to Solution.
01-04-2016 02:06 PM
The license is only applied to the ASA with the serial-number that you used while registering your PAK. In normal operation, thats fine and you don't need an additional license on the second unit. But if you later remove the unit with the license, then the remaining unit will also lose the license.
The best option would be to buy an AnyConnect 4 Plus license which can be activated on all your ASAs.
01-04-2016 02:06 PM
The license is only applied to the ASA with the serial-number that you used while registering your PAK. In normal operation, thats fine and you don't need an additional license on the second unit. But if you later remove the unit with the license, then the remaining unit will also lose the license.
The best option would be to buy an AnyConnect 4 Plus license which can be activated on all your ASAs.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide