About fmoulineau

fmoulineau · 04-04-2003

Hello,I wish to carry MED (BGP) from an AS1 to an AS3 via an AS2.By default, AS2 reset MED before sending BGP announcement to AS3.Is there a command a method to solve this ? Thanks

fmoulineau · 05-28-2002

Hello,I try to modify metric with bgp between 2 AS. I use route-map and "set metric 1000", but the metric 1000 is not announced in bgp update. I'm full BGP and i don't do any redistribution between my 2 AS. It seems that metric apply only to routes r...

fmoulineau · 04-04-2002

Hello,What are the best practises to solve this topologyI have several branch offices connected via BGPto a BGP core Network. Branch office X use 10.X.0.0/16 networkI would like that network core announces summarize10.0.0.0/8 to each branch offices.E...

fmoulineau · 02-08-2002

I intend to use E1 PRI for extra load of my primary 2Mb/s frame relay link. I would like to open E1 channel per channel as extra load require.I thought to do this:Use "backup load" on my primary linkUse "dialer load-threshold" on E1Use IGRP for load ...

fmoulineau · 04-05-2003

In fact, My site 1 & 3 are interconnected to BGP Backbone (AS2)with redundant architecture (on each site: 2 routers, 2 links).In the Backbone, I have also 2 symetric links between site 1 & site 3.Site 1 & site 3 run OSPF and are connected to backbone...

fmoulineau · 04-04-2003

Hello Roger,Is there a command or method to prevent AS from reseting MED (In fact, i would like to keep my MED end to end while passing through an AS).Best regards

fmoulineau · 05-28-2002

Thanks a lot for your help Faraz.In fact I don't have access to the router receiving update with MED (router of my client).I rapidly checked on a lab test that advertising MED can be not seen on the sender but present on the receiver.Best regards.

fmoulineau · 05-28-2002

Hello Faraz,My route-map seems correct, all the other parameter of my route-map are correctly take into account.I do several clear after change.Does metric modification apply in BGP without redistribution of an other protocol? François

fmoulineau · 02-12-2002

What about with routing and load balancing on 2 link with asymetric speed (primary link: 2 Mb/S and backupline increase by 64K-channel as needed) ? As far as I understand with OSPF, i first open a B-channel and then load-balance on both link (2M and ...

Member Since	‎02-08-2002 08:26 AM
Date Last Visited	‎06-25-2021 09:11 AM
Posts	9

User Statistics

User Activity

Carring BGP MED through an AS

BGP and MED

BGP summarization

Backup load - Unequal cost path load balancing

Re: Carring BGP MED through an AS

Re: BGP MED Value

Re: BGP and MED

Re: BGP and MED

Re: Backup load - Unequal cost path load balancing