Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys!Can I execute show commands using Netconf protocol for cisco IOS-XR 6.2.2 ?For example execute "show run" command using netconf.Thanks in advance.
Hello guys!
I'm trying to apply autoroute annouce command to PCE initiated LSP by using Configuration group command but without result. It doesn't work. Autoroute disabled for pce initiated LSPs.
May be I do smth wrong. Please help. Or advice anothe...
Hello!
Software IOS-XR 6.0.1
Can I use loopback address for comand Loopback for "mpls traffic-eng pce peer source ipv4" ?
When I set the ip address from loopback the packets stop to send.
It's a strange behavior to use only physical interface because...
Hello!How can bind PCE initiated LSP to L3VPN service if i don't use OCS with cisco-specific autoroute announce attribute? Can apply such configuration in another way ? Maybe through configuration group?
Hello xthuijs!
Yes, technically it should work because it usual function.
But when I change ip address from physical interface to loopback It doesn't send pcep packets at all...
Of cource I can ping loopback from PCE server.
