Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,We have two Nexus 5000 in HA configuration that use a switch port profile to share configuration changes.Earlier this morning the secondary switch rebooted (this has happened before).Just prior to the reboot the syslog server received the followin...
Hi,We have two ASA5580s in HA mode and are having the same issue as reported in June 2009. (Heading - ASA5520 inside shared interface). Until recently we have been receiving all syslog messages correctly. However now the syslog server is not receivi...
I've been tasked with configuring QoS across the network of where I work. Currently the configs have some legacy QoS statements on the switches for the voice VLAN but I'm not sure if they are working or not. These statements are meant to only mark ...
Hi,I have an issue with an upcoming project.Currently we have two routers where both the LAN and WAN interfaces (see attached diagram) are configured using HSRP for failover (see below for config details) with both interfaces being in their own subne...
Hi,I've been requested to restrict telnet/ssh access to the loopback address only.I've been attempting to do this using access lists however the access lists either block access to all interfaces or allows access to no interfaces.Any and all help in ...
Prapanch,Sorry for not getting back to you earlier.I think our issue is to do with having the same shared inside interface (in this case campus)When I do a packet-tracer command I get the following responses (rules are in and connectivity is working)...
Edison,Thanks for your quick response. I'm able to see the required information now.I have several other questions/clarifications regarding the upcoming QoS project and hopefully you can help.1. Should I continue marking the packets at the switch a...
Saurabh,Thanks for the help.To clarify a couple of things.The diagram is correct however both links connect to the same IPS. A single /24 public IP address range will be advertised by the ISP.As per the last posting I am concerned with the return tr...
Joe,Tested the access list on a test box and it work fine. Before I start applying it on all devices thought I would get you to have a quick look.Does the below look correct?Want to connect to IP address 10.1.112.5.ip access-list extended RemoteAcce...
