Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All, we are trying to setup DMVPN Phase 3 and need to enter the commands ip nhrp shortcut and ip nhrp redirect which is not possible on Cisco 1841 routers - IOS version advipservicesk9-mz.124-25f.binOn a cisco 1812 c181x-advipservicesk9-mz.124-2...
Hello,we have some ASA and PIX devices connected to an IOS Router in our main datacenter using IPSec L2L tunnels.Is it possible to create a "backup tunnel" between such an PIX/ASA and an other IOS Router in our backup datacenter ?We would like the tr...
Hello,in one of our contexts we have a sync problem on the standby unit."sh ft group detail" gives"Running cfg sync status : Error on Standby device when applying configuration file replicated from active", while "Startup cfg sync status" is OK. "sh ...
Dear all,we would like to monitor several ressource usages on our ACE module,but didn't have much luck so far. In particular we want to have MRTG graphs for :* CPU usageIn MRTG we tried "Target[lb-admin-cpu]: 1.3.6.1.4.1.9.9.109.1.1.1.1.7&1.3.6.1.4.1...
Dear all,we are planning to upgrade our Cisco Security Manager version 3.1.1 (including RME 4.0.6) to version 3.2. We already have downloaded fcs-csm-320-w2k-k9.exe and fcs-mcp-v32-w2k-k9.exe. As far as I understand the installation guide I have to i...
Hi Federico,thanks for your reply. I am still not sure about the routing.On the ASA I will have a static route pointing to the ouside interface, won't I ?How does the ASA decide to use the primary peer if it is up, but to use the secondary in the oth...
Hi,thank you for the reply.So one can not get the usage of other CPU using SNMP ? What about memory usage ? From your answer I understand that we can only monitor the total amount of connections (cslbxStatsCurrConnections) in a context, but it is not...
Hi Gilles,unfortunately I can not see a meaningful message. Can you please have a look at the attachments (taken from the standby machine) ?Thank you very much in advance.
Dear Gilles,thank you very much for your reply. This answers my question.But ... I would like to turn this into a feature request, because I believe this demand is not that much out of common. There already is a https probe which works in a similar w...
Thank you Gilles.The services run on the standard ports, which are different from each other.Ok, but back to my question : do I have to use different VIPs or can I use the same one for all ? Do you have an example config ?
