Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all.We need to calculate the percent of collisions in a catalyst 5000 switch port. We've being studying a very interesting cisco document, 'Troubleshooting Cisco Catalyst Switches to Network Interface Card (NIC) Compatibility Issues', at http://w...
Hello.We've got a pix installed without its failover unit, and last day due to a network failure, it passed to standby state and trying the nonexisting failover unit to take over control. We solved the networking problem but the machine stayed in the...
Hello all.I'm trying to configure a Pix 520 with 4 interfaces, 2 of them connected to different Vlans, and the other 2 connected to different ADLS routers atached to the internet.We pretend to 'save' firewalls by means of using less firewalls with mo...
Hi all.I'm having problems with configuring some identical pix 520. We had available 4 pix. Two work right when configuring them, but the other two we're not able to make them work, with identical configuration and communications enviroment for testi...
Hi.See http://www.cisco.com/warp/public/473/53.shtml, at 'Possible Causes for Incrementing CatOS Counters', where you can read:'This is an indication of excessive output rates of traffic. This is also an indication of the receive buffer being full. T...
Hi Glen.First of all thanks for your reply.The matter is that the 'sh int' does not give that output info, but this one:Catalyst5000# (enable) sh intsl0: flags=51 slip 0.0.0.0 dest 200.123.5.144sc0: flags=63 vlan 12 inet 10.0.0.2 netmas...
Hi Bryan.The version of IOS is 5.0.3. We have other pairs of machines connected in failover, and we still have to do it with the rest. I had supposed that maybe pix were built to work in pairs, and that's why it didn't work fine standalone.Anyway, we...
Hi.We have the pix standalone by now, without its failover unit connected at this moment. That's why it's strange the failover state to start.When that happened, we entered 'no failover' command, but the problems didn't disappear. So we rebboted the ...
