Hi all.
I'm having problems with configuring some identical pix 520. We had available 4 pix. Two work right when configuring them, but the other two we're not able to make them work, with identical configuration and communications enviroment for testing all four.
The machines were second hand, so we had to change the password, but we didn't change the activation key. They were beeing used for ipsec (two as failover units).
We have made actualizations of the software as well in some cases, downgrading the software again to the original software in other cases, without changing the activation key never, but that don't solve the problems neither.
Even we have erase the flash (write erase) and installing the software again but didn't work at all.
We're configuring them with nat, global and conduits, and when we enter '# conf mem', we're responded:
pixfirewall(config)# conf mem
Duplicate NAT entry
Config Error -- route outside 0.0.0.0 0.0.0.0 192.168.x.x 1
Config Failed
Then we try to erase the two entries in terminal configuration, (no nat ..., no route...) reenter the commands (when clean) again, and make write memory, but it didn't work.
So I don'tknow what's on. What am I doing wrong?,and is ther any document concerning to structure and managing pix memory?
Greetings and thanks in advance.
Jose Luis De Diego.