Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have set up a level 5 user and a enable level 5 password.I set priv exec level 5 show running-config I also have AAA default local set.when I login as enable level5 and do a sh run I get 3 lines of config
I have 2 5548 runing vPC. I wan to connect another 5548 to those using a Port-channel. the 3 rd switch is for device with only 1 NIC and to keep having fanthom ports.When I create another Port-channel on the 3rd sw and connect it an interface...
I have question as to the best way to perform the task of sending syslog to my logging server on the inside of my network.I have a couple rotuers and a DMZ with some device in it that I need to collect log info from. I have a 5525X connected to exter...
I have a project that requires 2 data centers, one for a hot standby. I have 5 remote offices that need to connect to data center 1. In the event data center 1 goes down then I need the 5 remote sites to connect to data center 2. All 5 remote offices...
only allowing your active devices on a mgmt network to access the ntp via an access list. Seperating the control and data plane traffic could help prevent this.
So if levels 1-14 are custom and I say priv level 5 sh running-config doesn't that allow level 5 to see running config. I thought I added that the level
