Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Is that FWSM support for Source NAT??If so, can anybody tell me how to do that?our requirement as follows.We have statically NAT 192.168.1.1 to 220........public IP.When a packet comes from outside the original source (public IP) shows to the dest...
I tried to configure sub interfaces in our Cisco 2611 router as follows. Router1(config)#interface fastEthernet 0/1.1(config-subif)#ip address 172.16.2.0 255.255.255.0but this gives the following error.% Configuring IP routing on a LAN subinterface i...
We are going to install two ASA 5520 boxes with HA ( Active-Active or Active-Passive )The boxes include 50 context licenses(virtual Firewalls) and SSL VPN licenses 750 Nos. each. IS it impossible to use VPNs and contexts licenses with HA?
Is it possible to create a IPSec VPN, Site to site VPN on Cisco 1721, or 1841 without additional modules.If so, pls provide an example configuration.Kosala
Yes. But the client need to change that 'source IP on the internet (from the client).'and show the source IP as 192.168.1.254 (which ll be the gateway of 192.168.1.1 which is on FWSM)
Dear All,This was a discussion, we had about a year ago.But I think still we are not getting the solution. Hope that I m correct.Still we can t create IPSec VPN tunnels etc in Multi context mode.We are facing problems, because CISCO has not going to ...
But my router, the version is newer.Pls. check the show version output....Cisco Internetwork Operating System SoftwareIOS (tm) C2600 Software (C2600-I-M), Version 12.3(17b), RELEASE SOFTWARE (fc2)Technical Support: http://www.cisco.com/techsupportCop...
