Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have tried several IOS images and finally found that the Service Provider image (c1841-spservicesk9-mz.124-24.T5.bin) finally seesthe cable modem HWIC, but i constantly get RBCP errors and Comcast can not see the router, nor can I see the com...
Did you get this to work, because it sounds like you are trying to use the 877 as a wireless bridge, which I am not sure it can do. Both 877's wireless interfaces are trying to be master. If you want to create a wireless bridge you can use on 877 a...
After using the reset method above, the default IP addresses for each device should be:MM (ETH0, outside) 192.168.70.125MM (ETH1, inside) 192.168.70.126Bay 1 192.168.70.127Bay 2 192.168.70.128Bay 3 192.168.70.129Bay 4 192.168.70.130
While the CGESM does not support 802.3ad, it is not needed for Active/Standby NIC teaming. Set your server software to NFT mode and it will work just find.
On the CGESM, I dont think autoneg works properly on the GLC-T= module. SO setting both sides to Speed 1000, duplex full. will probably fix your problem.
You can interconnect them via the uplinks in a psuedo ring. Each 3020 has 8 GE uplinks, so you can send four left and four right and have a 4GE ring between the switches. Clustering is not supported on 3020s. We have a new feature which is called ...
