Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I currently have a UC320W setup in a blended mode. We have 4 POTS (3 are set as shared fx0, the existing phones now all say no buttons available) lines connected to this device for inbound/outbound calling. We are using the spa504g phones with this...
with the uc320w and the spa504g phones, is it possible to have different ring types for internalvs external calls? Seems like I remember reading about it somewhere but I can no longer find referenceto this if it is possible or not. If it is possibl...
When attempting to login to the uc320w web interface, after typing in username & password, I am consistently getting the attached error message. If I repeatedly exit the browser and login (usually about 4 times), it will finally load. What could be...
Currently, we are utilizing the uc320w with the add on spa8800 gateway, an esw 24port poe switch, and spa504g phones. The location for one phone is about 400 feet from the poe switch (moving this is not an option) and the distance exceeds the line c...
The walkthroughs and sample configs have been invaluable in doing my first uc320 deployment--thanks to all that have contributed these to the community. Is there any emulator or virtual environment where a config could be loaded and "tested" prior t...
Need to ammend this thread....Reseting the phone to factory default and/or restarting phone appears to solve this issue; however......this issue keeps occuring on a daily basis. Each time I need to access the web-menu for the uc320, I get the error ...
firmware version is 2.0.6 (10)the 10.1.1.111 is one of the phones on the VLAN. It is one of the phones on the voice vlan; I just confirmed. The system (uc320) is assigning the addresses in the 10.1.x range.
I currently have a PMF request in for this exact functionality. "They" are unsure as to whether or not it will be created or not; check back on the PMF page frequently. In the interim, I have created cards for the phones (kind of sad to have such a...
@Chris:please don't spend a whole lot of thought on this, I spoke to Cisco this morning and as someone else stated, any/all modifications to the phones must be done at the uc320, any customizations done to the phone would be immedately over-writen. ...
