Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have a question about service policy.the topology is pix---3550---l2_sw---clientsi want to use service policy to limit the rate to 6Mbps. the following is my configuration. however, i can not verify it via the command "show policy-map interface"the...
if your 10.x.x.x network is connecting your router dircetly, that means your router has a interface which ip address belongs to 10 network and the hosts in the 10 network point to their default gateway to this address of router's.if you want the host...
as you can see from the name of frame-relay, the meaning of relay is that the frame received from one segment will be relayed to another segment base on the map of frame-relay switching device. so you can treat frame-relay as point to point link, tha...
before deciding which protocol you want to use, the first thing is design your network with continuous ip address space which is important to all routing protocols. and then you can summarize your network properly.as you mentioned, your network seems...
