Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Question on BGP Routing of ISP IP to internal IP addresses. We have an MPLS network for our locations. We are going to be implementing their internet access through the MPLS to an internet port in the providers network. They will need to have access ...
I wanted to see if someone has saw this before. We are setting up a SPAN session on a 3750X stack(2 switches) to monitor the inside interface of a ASA5510. As soon as I set the following on the switch the AnyConnect kills all sessions and you get an ...
I setup this QoS after doing some research, however, I am not sure it is set up correctly. I am concerned that the Critical Date is tagging the traffic I setup in the ACL. If you have any feed back I would appreciate it. The link to the MPLS is 10M e...
I have a question that I have been working and can not seem to figure out. I have 2 ASA 5510's. Both have Internet service's from two different providers. On one I want to use for VPN access for remote users to connect through, the other I have a VPN...
Question on ASA VPN tunnels. I have one ASA 5510 in our corporate office, I have two subnets in our corporate office that are configured in the ASA in a Object group. I have a site to site IPSEC tunnel already up and that has been working. I am tryin...
Good, I wanted to make sure that I didn't need to add anything to the BGP on my end. I added the route to their network to point to the MPLS Edge router and I am able to do a ping to there server/firewall.
Thank you for the reply.
OK figured out what was causing the issue. The previous admin setup the switches and mislabeled the switches. Once I checked the through CLI I discovered that I was seting up the monitoring on the wrong ports. Lesson learned, don't trust someone els...
This is the only session for that inside interface, or any other interface for that matter. The monitoring platform is a Palo Alto 5050, this is the first I've used it, we are testing it in our environment. I am very confused why the Anyconnect gets ...
I am learning more as I go along here, still haven't implemented the QoS but I think I am getting closer. Once I get this done I'll post what I setup and you can take a look, if anything it might end up being entertaining. Thank you everyone for your...
OK, I asked the equipment provider how the voice gateway's are tagging the traffic, their response is that it is tagging it IP Precedence = 5How does that work with the voice and signaling classes, I'm not sure. I am going to contact the manufacturer...
