Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have ISE running on my network and I have 802.1x authentication on all access switches. The authentication happens through a pool of RADIUS servers that are configured on all the switches. I am facing a problem with one of the RADIUS servers. That ...
Hello,Our ASA is configured with a public IP address on its outside interface. This public IP is part of a subnet that we obtained from our ISP. Recently, we have used up all the IP address in this subnet and we obtained another subnet. I want to sta...
Hello,I have two 6509 switches with ACE modules installed and configured as active/standby. There is no FWSM installed, so MSFC shares a common subnet with the external interface of ACE. On both MSFCs, I can see the static route injected (RHI) by ACE...
Dear freinds,I need a help understanding why brigding between 2 interfaces on a router does not work until I create a BVI interface. Briefly, my setup is as follows:I have a 6506 core switch connected to a 3845 router with 2 GigaEthernet interfaces. ...
Thank you Adeolu for your reply. What I was looking for is a mechanism where the pool can be modified from a central location or a dynamic way to remove a RADIUS server from a pool that is configured on all the switches.I can use Cat Tools to apply t...
Hi Jouni,Thank you for your response.The upstream router was configured with a route towards the outside interface IP address of the ASA, which belongs to the old subnet.I have tried to place my PC on the outside of ASA (just L2 with the outside inte...
