Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
I tried to configure Port forwarding to Local DVR to Public IP address but its not working
Device Cisco ASA5516-XSFR (IOS 9.12)
Public IP address xxx.xxx.xxx.12x
Local IP address 10.10.8.25
Ports need to be forwarder : 554 ,8000, 81 all are T...
HiI am facing a problem with icmp in ASA 5505, i want to block the icmp from inside to outside , but outside to inside icmp should work, here the configuration. ASA Version 8.0(5)!!interface Vlan1 nameif inside security-level 100 ip address 192.168.1...
Hi I am configuring Cisco 2911 Sec-k9 router. i am able to block all the sites but not able to block Https Trafic like Facebook,youtube,some unwanted Sites. how to block them. i tried with key word blocking, but still https Sites are opening.and i wa...
HI ... I have configured 1941-sec router for my client 3 months back for Autofailover and Load balance. it worked well. but from past 20days .. auto failover is working .. one the 1st ISP cable physically disconnects.. and not able to access the dev...
Hi I configured Cisco ASA5510 firewall, but i am facing the problem with ssh login, i gave ssh for inside and outside access, but i am getting "server ... error" i enabled LOCAL for the authentication for ssh and HTTP. and i am able to acees the dev...
HI Please find the out put 1). after no default route XXXX_RTR#sh trackTrack 1 IP SLA 1 reachability Reachability is Up 14 changes, last change 05:27:47 Delay up 10 secs, down 9 secs Latest operation return code: OK Latest RTT (millisecs) 1 ...
Hi Alain if primary goes down.. secondary is not comming up automatically, ifi remove the primary cable then only the secondary line will come......if both links are up i am not able to access the device through the primary link...thanks in advance R...
HI Scott yes it is in the AP management IP subnet only and its joingin with the wlc with DHCP IP address, but it is showing this meggage and rebooting . and i reseted to the factory default , and i don't have access to the WLC,Mar 1 00:00:36.272: ...
Hi Amerright now cleared the configuration from the router, due to some issues, the procedure i followd is,, 1) channel-group 2) dialer 3) voip .. is it correct which i did. if possible can you tel me the mistakes , and which channel group i need to ...
