Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Im using FlexConnect/OfficeExtend with central switching on a 5508 WLC and the encryption option enabled from a 2702i accesspoint. But the performance is really low. Around 10mbit/s.
I need to use central switching to reach office resources so lo...
Hi,
Just saw that udp/161 was open even though we have an ACL on snmp community -WHY IS THAT?
SNMP is closed so that i cannot do a snmpwalk, but it's concerning that udp/161 is still open.
snmp-server community ********************* RO SNMPACLsnmp-...
Hi,we are planning to replace some older accesspoints which all have the AIR-ANT2465P-R antenna.The accesspoint im looking on is the 1602E.Would it be possible to still use those antennas with the 1602E accesspoint considering only using output A & B...
Hi,after upgrading to 7.4.100.0 im getting this error message when trying to apply changes on the wlan id."mDNS profiling cannot be enabled with flexconnect local switching"if unselect mDNS snooping under (wlan id/advanced) i can apply the changes, b...
Hi,
Did you ever get the speeds up using Office Extend? -Im seeing exactly the same results. Tried a bunch of different ap's 1142N to 2702i all around 10mbit/s performance using Office Extend and encryption.
/Marcus
Hi,No we have to use those antennas since they are wall mounted and directed down isles in a warehouse. They have been working perfectly with our old 1020 ap's. But now we're going to replace those old ap's with something newer because of replacing t...
Sure, i would like disable mDNS for that wlan.When i unselect mDNS snooping i can apply the settings.However when i check the settings again, it's eneabled again, all by it self.i don't understand why it's always enabled?
