Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i think, you are running this ap in lwapp mode. try this doc http://www.cisco.com/en/US/partner/docs/wireless/access_point/1130/installation/guide/113h_c4.html#wp1091047 to return to autonomous mode. in lwapp mode you cannot configuring ap, ap is con...
I see...So, we know networks and hosts, and with regard to subnetting we know networks (class full) and subnets. 192.168.10.0/24 is class full network "C" - 192.168.10.0; but 172.16.10.0/24 is subnetted class full "B" (with natural mask /16) - the n...
Today, this term does nothing than history. In the past, in beginning of using subnets, there was problem with subnets all 1 or all 0 (i can't remember why ) and these subnets were forbidden. Than you had to explicit permit using zero subnets, but ...
Hi,ip-subnet-zero means, that you can use "zero subnets", i.e. subnets with all 0 or all 1. Example: you can use subnet 192.168.10.0/26 - it is C-class IP 192.168.10.0/24 (24 class-full bits) with subnet part (2 bits) - all zeros and 6 bits for host...
yes, of course. this is what we discuss - you have to use L2 (PPP,FR), you cannot group logical channels (e1/3) on L1. E1 (in mode c-12), resp. E3 (in mode e3) is the base rate and cannot be grouped to build higher rate, it is not in SONET or SDH sta...
