Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Edison, I dont think that port-channel is to blame here, If it were in a port channel the error would not be;Mar 2 02:48:40.788: %SW_MATM-4-MACFLAP_NOTIF: Host 503d.e5af.9c40 in vlan 1 is flapping between port Gi0/5 and port Gi0/22I would expect it ...
Hiho, Hey Pete This is default behavous for the 7600 (I know it's kinda crazy!), there is a tech doc for it;http://www.cisco.com/en/US/products/hw/switches/ps700/products_tech_note09186a00801c9b4e.shtmlYou can change the MAC address using mac-addres...
Heya,but my question is , will it succeed if i performed route map and poicy on G i1/1and typedset ip next-hop to Gi1/2The above will just send the traffic back to the 2960 switch out of the G1/2 interface on the MLS. What the switch will do with it...
Peter,Nitpicking is good, the little details make the bigger picture work, So I thank you. I can see how easily mixed up these two can become as they are quite similar in nature.I am on these forums to try and learn as much as help, after all everyda...
Peter'My bad, just reviewed that post. So to clarify,The switch (assuming its layer 2) should not be effected as its got no ARP mappings/entries. Just the router or switch if its a MLS will have ARP entries.But the sessions will remain will they not?...
