Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All:I'm having trouble configuring a backup dialer when my primary circuit goes down. I have a point to point circuit setup over the internet that connects to my router via FE1/1 port. I have a Good Old Fashion Multiteck 56K modem on POT ...
I'm having trouble getting my backup dialer to work using the Reliable static routing object tracking and was hoping someone could help.I just went form a serial T1 link to a priivate tunnel via ethernet interface and so my backup dialer plan no long...
I have a Cisco 5508 setup at a host site with 3 other sites connected using hreap on 1252APs. When doing testing of network speed I find that the throughput from the wireless to wired network is at about 18mbps yet the same test on wired side is 85-...
what tells the modem to start dial up? this is not a ISP issue this is point to point circuitand I do not use "default route I use EIGRP to route anything on circuit 172.31.0.0 ( tunnel ) for point to point
