Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Thanks, but that's not my issue... My DGW is correct in the DHCP scope, and other clients seem to be working just fine. Like you it came up on the trunk port just fine when it came up to provision the AP, but now after reboot it won't pull an AP. ...
What was your misconfiguration? I seem to be having the same issue, but I have a very simple DHCP config, basically sending a client a DHCP Address, DNS Server and Default Gateway...
Steve,I had the same problem. I had 2 WLANS mapped to the same interface. When the iPad and the ATV were on the same SSID then Airplay would not work. When the iPad and the ATV were on different SSID's (same interface mind you) then Airplay WOULD ...
You need to set the Public IP address that the traffic is getting NATTED to on the Interface Config on the controller, as that address gets embedded in the CAPWAP response from the controller to the AP as well. You also need to enable the checkbox t...
