Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI'm a Cisco novice looking at how to provide an automatic failover solution for a primrary fibre link with a secondary VSAT connection. I have been looking at IP SLA which looks straightforward, however the data being sent over the fibre has been s...
Hi there, I'm new to the forum and to Cisco having spent most of my working life in Nortel land. I am looking for advice as to how to limit bandwidth for the following tunnel config - !bridge irb!!!interface Tunnel1 ip unnumbered Loopback0 ip route-c...
The VLANs are phyically configured on FE ports on a switching module but with no ip address sadly. Is there any other methodology of providing failover for layer 2 VLANs?
Thanks for replying Joesph. So think because we are bridging it may not be possible to police / shape the traffic on this tunnel? So I should perhaps look at a different means of keeping this traffic isolated and shaped across our link?
