Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Each fabric module has a 220G connection to all slots in the chassis so it doesn't matter from a redundancy standpoint where the modules are. The more fab modules you add, the more aggregate bandwidth per slot you have. Same for power, redundancy is...
You can break out the single 40G port into 4 separate 10G ports and use a QSFP to 4 LC breakout cable to connect one or more of the 10G ports to the 7706. You have to enter the following command to enable the 10G breakout of the 40G port though: int...
I assume you already have applied for and recieved a public ASN from ARIN. You will need to advertise your /24 to both your ISPs via BGP. On your backup link, you can do an AS prepend on your backup router to artificially increase the AS path to yo...
If you have a monitor session set up and the source is a vlan, you will get a copy sent to the span port when the packet enters the VLAN (rx) and another copy of the same packet when it exits and access port (tx). To get around this you can set the ...
The classful network boundary for 172.30.x.x is /16 not /24 (it is a class B network) so you won't see the loopback addresses redistributed unless you use the subnets keyword in the redistribution statement under ospf.
