Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a TLS network provided by our local LEC. Basically we have a 100Mb coming into my office that I connect 10 other sites to and they range from 2Mb up to 100Mb. So basically I do not control the equipment that limits each side down to the purc...
I have a 3560 and 3550 Catalyst switches on version 12.2 IOS. I have one of the switches (Switch 1) with IPSERVICES for the IOS and the rest with IPBASE. On the Services switch I have PIM sparse-mode configured for VLAN 1interface Vlan1 ip address ...
We have a Subscriber and a Publisher CCM 4.1 servers. I have set up my Dial Peers to use both of them. Basically I want to have it fall over to the other server and if one server is down for any reason and have it fall over automatically. I have a...
I am trying to get Multicast packets to cross VLANs on a 3560 switch. I have IP phones off VLAN 2 and the rest of the network on vlan 1. Port 1 is only in vlan 1 and the rest are trunk ports in both vlan 1 and 2. Phones are Vlan 2. I have routing tur...
I have a CAT 3560 switch on 12.2.25.Neither the ip multicast-routing for the switch nor pim sparse-mode for the vlan interface is available for this IOS. I looked to see if could go to 12.3 or 12.4 but there is no version of IOS for this switch.