Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 1010 Firepower device that is managed by an FMC. the CLI Password on the device is not what i want it to be. If I change it, would it break FMC Access?
I have a cloud provider that I need to allow access to a specific port through my firewall. as of now I have had to add every one of their IP Addresses as a network object, and then group them so I could provide access through the firewall in my acce...
Hope this helps someone. I went through a newly developed issue regarding Site to site tunnels. I had to make a new site to site tunnel between two sites. I routed all DNS through the tunnel to a DNS server on the other side until I could create a DN...
I'm in the process of upgrading all of my firepower devices from 7.2.8 to 7.4.2 as it is the suggested release. we use the data interfaces as the management interface for most remote devices. As I upgrade each one, I'm now presented with a critical w...
I'm looking to enable Ikev2 for anyconnect and disable SSL.My concern is on the change log when I go to deploy it, the IPsec Proposal says port 443.We nat Port 443 down to out on site exchange server for hybrid email.Our SSL vpn has been redirected t...
I tried that with Management 1/1 but when I turned off my exclusions the warnings for management0 came back. thank you for trying to help. I appreciate it.
this didn't work. the exclusion is for Management 1/1 but my warning is for management0. I still have health warnings on all the devices that use the Data interfaces as the management interface. there is no option for "management0" in the list. ...
I found it. you need to go to Devices / Device Management, Select the Device, and go to Health / Excluded Check Interface status in this screen and the warning goes away.
