Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Im getting this error when I try to run Epld updates.Could not extract EPLD images, Insufficient space in bootflash.Failed to extract EPLD image file, Exiting.. I have allready delete some of the NXos bin files I downloaded. I'm currenty running 6.1 ...
Has anyone upgraded the fabric modules and memory on the sup to to 8 gig and upon boot up the sup's come up ok but the rest of the modules do not. I still want to upgrade the NxOS but cannot due to the modules not coming up correctly tried a cold re...
Not to familiar with the N5k. So here is my issue, I trying to connect n5k via two 10 gig ports to N7k 10 gig ports on a portchannel with truncking as well.this is only for traffic to pass thru just a uplink. I have two different port channels on bot...
I am trying to get our DCNM to discover the 5548. When I put my credentials for that appliance. I get this error .Failed Device x.x.x.x OS Version 5.1(3)N1(1) is not supported . Does anyone use DCNM and seen this problem. Any help would be appreciate...
Does anyone know if you can create range similiar to the old acs version such as this 10.1.1-15.1. On the new ACS This usually does the entire range for the old version. Or do you need to list them individually under the ip range tab. Any Ideas.
Here you go sir. And the portchannel are no shutdown on either side or the interfaces as well. ThanksN7k102 Po102(SD) Eth LACP Eth4/15(D) Eth4/16(D)N5k103 Po103(SD) Eth LACP Eth1/3(D) Eth1/4(D)
Thanks for the replySorry I sent the wrong config please disregard the one above. This is the one that is active now.N7k Configuration: interface port-channel102 description Uplink-N5K-TestSwitch switchport switchport mode trunk switchport trunk ...
