About SREENATH R

SREENATH R · 02-05-2016

HI Team , Good day !!!! May I know how to modify speed and duplex under a working trunk interface : I am using the image of : c2960-lanbasek9-mz.122-55.SE9/c2960-lanbasek9-mz.122-55.SE9.bin ( model : WS-C2960-24TT-L ). I have tried to modify the s...

SREENATH R · 08-20-2015

HI All,We have a requirement whereby we need to tag the physical interface (please note: not the sub interface) of a router to a particular vlan. I am aware of how to do this on the sub interface and for what I am trying to do, I want to avoid creati...

SREENATH R · 12-26-2012

Can we use ACL or routemap to control/block the packets which is going to the control plane or management plane of ASR 9000 routers and how is it possible ?

SREENATH R · 08-21-2015

Hi John,Yes ,the above configuration is right and it is working fine. Don't compare this configuration with my first scenario as there is no connection between these two. I just need to know how it is working fine ? I am expecting your precious reply...

SREENATH R · 08-21-2015

Thanks Jon. I would like to understand the command " vlan-id dot1q 45 exit-vlan-config " is not making any tagging on the router interface. As we all know the encapsulation will apply usually on sub-interfaces . But here the thing is on physical in...

SREENATH R · 08-21-2015

Hi Jon,My intention is to find why such a configuration is there on the switch and router. But I am sure it is working fine between switch and router. I need to know how the below config is working fine in between the switch and router ? I guess the...

SREENATH R · 08-20-2015

Hi Jon, I appreciate your help. If use the following set of config in the corresponding connected switch port , will it work in right way ? I meant to ask, if the switch forward a packet to the router gi 0/0 , the switch will not tag any vlan id for...

SREENATH R · 11-14-2013

Hi Harold Ritter, As a part of your conversation. I would like to clarify one doubt. As my knowledge I know if we want to enable MPLSin Cisco routers we should enable CEF first. Because then it can create adjaceny table and FIB and based on FIB it ...

Member Since	‎12-26-2012 04:02 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	12

User Statistics

User Activity

To modify Duplex and Speed manually under trunk interface

VLAN Tagging on the router (cisco 2821) physical interface

Apply ACL/Routemap to protect control plane

Hi John,Yes ,the above

Thanks Jon. I would like to

Hi Jon,My intention is to

Hi Jon, I appreciate your

Re: Cisco & Juniper MPLS