Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, i have an ASA 5505 which is unable to acces the internet, even when reloading just the basic config.If i setup my laptop with the outside ip or another ip in the subnet, it does work.This is the current config:: Saved
:
ASA Version 8.4(4)1
!
hos...
Hi, We want to use a Cisco 861 ethernet router to link our LAN's data and voice segments together (each on separate switches). Our switches are not Layer3 so routing over them is not an option. We only use the default VLAN1 on both switches.There is ...
Hi,We just changed ISPs and now have a /29 routed subnet to be used on our ASA 5510 (8.4) instead of the one public ip we had before.There are a couple of PAT translations that were previously setup on the "interface" address which i now want to assi...
Hi,We have an ASA5510 with the Anyconnect Essentials license. I'm in the process of setting up Anyconnect and immediately run into a question. We have a /29 subnet setup and AFAIK i must use the outside interface address for Anyconnect. However i alr...
Hi, I have an ISR 1921 SEC as a router for my internet connetion (/28 subnet). On the inside is an hp Procurve 1900 switch which supports basic routing (static routes).Suppose i want about 10 VLANs on my LAN, all with different subnets (eg. 10.0.1.0/...
No, didn't work.Tried write rease, new config. Even downgraded to 8.4, but for the life of me i cannot get this thing to access the internet anymore.Any other ideas?Dennes
Well.. This is embarrassing..Turned out that everything is just fine, but a reboot of the Exchange virtual machine to which the PAT's go, caused it's address to change to a DHCP assigned address. Reset it back to the static LAN ip and it's working li...
I did the show and clear xlates, but to no avail.I want it to be setup something like this:interface WAN ip: 1.1.1.1WAN ip 1.1.1.2 tcp/25 --> 192.168.1.10WAN ip 1.1.1.2 tcp/443 --> 192.168.1.11This should work, right?
Thanks guys!I think i'll just change the DNS record to point to another ip in the subnet for my Exchange/Activesync HTTPS, just as Karsten pointed out.Dennes
