Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm configuring a new 2911 running c2900-universalk9-mz.SPA.151-4.M4. In the config by default is "line 2" its not a vty, aux or console line and I can't remove it, Has anyone seen this before?line con 0exec-timeout 15 30password Removedloginline ...
Running a m9134 with 3.2. Trying to configure callhome to send a user defined command when a port is disconnected. Callhome works fine.This also works fine when I run "callhome test".but I can't get it to work when a interface changes status I.E up...
Hi, I'm having an issue with NAT on a Pix 525 running 6.3.4. I have two IP Address that I'm using a static nat on, one works and one does not. Here are the static entriesstatic (inside,vpn) 63.xxx.xxx.37 10.200.100.131 netmask 255.255.255.255 0 0sta...
I have a site with approx 25 switches, 2 3750 G-12 stacks of two are the distribution layer for the complex. There are redundant links to both sets of stacks. Spanning-tree keeps re-calculating based on topology changes of links losing protocol. ...
I have 2 10meg EPL circuits, each one connected at layer2 to different 4k switch. Is is possible to wrap both of them in a etherchannel to get 20 meg circuit while they are on 2 different switches?
Tried that, got the same result. One works and one does not. Is there a limit or something on static nat's? Is there a debug that I can use to see why it's not being nat'ed?
Sorry about the confusion. The flow is like this 10.200.100.131 > 199..x.x.xThat traffic gets routed to the VPN DMZ and the 10. address NAT'ed to 63.x.x.38That traffic flow, 63.x.x.38 > 199.x.x.x should bring up a VPN on my concentrator . I can run ...
